A band-pass filter has a bandwidth of 250Hz and center frequency of 866Hz. Find the quality factor of the filter?
Question
A band-pass filter has a bandwidth of 250Hz and center frequency of 866Hz. Find the quality factor of the filter?
Solution
To find the quality factor (Q) of the band-pass filter, we can use the formula:
Q = center frequency / bandwidth
Given that the center frequency is 866Hz and the bandwidth is 250Hz, we can substitute these values into the formula:
Q = 866Hz / 250Hz
Calculating this, we get:
Q = 3.464
Therefore, the quality factor of the band-pass filter is approximately 3.464.
Similar Questions
The above figure exhibit the response of the band pass filter. fL = Lower cut off frequency = 100 HzfH = Higher cut off frequency = 10K HzGain at the fH is 15 dBWhat will be the Q factor of the filter?
The quality factor of a wide band-pass filter can be
The Q of a band-pass filter depends ona.the center frequency and the bandwidthb.only the center frequencyc.only the bandwidthd.the critical frequencies
The above figure exhibit the response of the band pass filter. fL = Lower cut off frequencyfH = Higher cut off frequencyGain at the fH is 15 dBWhat will be the gain (theoretical) at the central frequency?
A filter consist of resistance = 25k Ohm. and capacitance = 220 pF. Find out the cut of frequency.28.937 KHz2.8937 MHz28.937 Hz2.8937 KHz
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.