Knowee
Questions
Features
Study Tools

The depth of cut of the paring off operation on the center lathe is based on:Question 10Select one:cutting speeddimensions of the cutting toolradius of work partdiameter of work partfeedrate

Question

The depth of cut of the paring off operation on the center lathe is based on:Question 10Select one:cutting speeddimensions of the cutting toolradius of work partdiameter of work partfeedrate

🧐 Not the exact question you are looking for?Go ask a question

Solution

The depth of cut of the paring off operation on the center lathe is based on the diameter of the work part.

Here's why:

  1. The diameter of the work part: The depth of cut is directly related to the diameter of the work part. A larger diameter would require a deeper cut and vice versa. This is because the depth of cut is essentially the amount of material being removed from the work part, and this is determined by the size (diameter) of the work part.

  2. Cutting speed, dimensions of the cutting tool, radius of work part, and feedrate: While these factors can influence the quality and efficiency of the cutting process, they do not directly determine the depth of cut. The cutting speed and feedrate are more about how fast the cutting process is carried out, while the dimensions of the cutting tool and radius of the work part can affect the type and size of cut that can be made. However, none of these factors directly determine the depth of cut in the way that the diameter of the work part does.

This problem has been solved

Similar Questions

QUESTION:What is depth of cut? Depth of cut is the:POSSIBLE ANSWERS:Total surface measurement of the discarded workpiece material.Measure of how far the tool plunges into the workpiece.Width of the tool subtracted from the workpiece diameter.Linear length of the cut along the machined workpiece surface.

A straight turning process reduces the diameter of a cylindrical work part from 121 to 107 [mm]. The feed rate is set at 0.15 [mm/rev]. The cutting speed is set at 39 [m/min].  The work part material has a specific cutting energy of 1.5 [W.s/mm3].  Machining power in [KW] is then given by: Question 7Answer1.020.0616.672.051023.75

If the average cutting speed on a shaper is 15 [m/min] , speed ratio 0.7, work part length is 168 [mm] and both start and end allowances are 1 [mm], raw material width is 77 and start and end allowances are 1 each.  Machining time is _______ [sec].Question 3Answer176215911835

In what axis must an operator touch off and zero the cutting tool for facing operations on the engine lathe?POSSIBLE ANSWERS:Z axisY axisX axisC axis

What angles describe the space between the tool flanks and the newly cut workpiece surface?POSSIBLE ANSWERS:Rake anglesRelief anglesShank anglesShoulder angles

1/2

Upgrade your grade with Knowee

Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.