When a new remote network is onboarded, select Enable Secondary WAN when which option isbeing configured?active/active connectionactive/passive connectionpassive/passive connectionEqual Cost Multipath Routing (ECMP)Next
Question
When a new remote network is onboarded, select Enable Secondary WAN when which option isbeing configured?active/active connectionactive/passive connectionpassive/passive connectionEqual Cost Multipath Routing (ECMP)Next
Solution
The option "Enable Secondary WAN" should be selected when configuring an active/active connection. This is because in an active/active setup, both WAN connections are used, which requires enabling the secondary WAN.
Similar Questions
What is Enable Secondary WAN is used for?configuring a secondary LANECMP load balancingcreating a passive secondary IPsec VPN tunnelcreating an active secondary IPsec VPN tunnel
The new routes can be chosenQuestion 1Select one:a.Independently choose route for each packetb.Set up a route when new connection establishedc.Act depending upon the trafficd.Both a and be.None of these
Before you can onboard a new remote network, you must configure the items shown in whichoption?portal and gatewaygateway and tunnel interfaceIPsec tunnel and portalgateway and IPsec tunnel
Which channel group mode must you configure on both ports to enable a static EtherChannel?Question 10Select one:ActiveNewOnPassiveAuto
A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode auto . Which command must be used on SW2 to enable this EtherChannel?SW2(config-if-range)# channel-group 1 mode onSW2(config-if-range)# channel-group 1 mode desirableSW2(config-if-range)# channel-group 1 mode activeSW2(config-if-range)# channel-group 1 mode passive
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.