Why does the water go into the bottom of a water condenser and not the top?Group of answer choicesA. So that the water fills the condenserB. So that the cold part is at the bottomBoth A and B are correct!Actually, water should go in to the top, not the bottom
Question
Why does the water go into the bottom of a water condenser and not the top?Group of answer choicesA. So that the water fills the condenserB. So that the cold part is at the bottomBoth A and B are correct!Actually, water should go in to the top, not the bottom
Solution
In a typical laboratory setup, water enters a condenser from the bottom and exits from the top. This is done to ensure that the condenser is always full of water. If water were to enter from the top, it could potentially flow out before it has a chance to fill the condenser, which would not be as efficient for cooling.
The second part of the statement, "so that the cold part is at the bottom," is not entirely accurate. The temperature of the water should be relatively uniform throughout the condenser. The purpose of the water is to absorb heat from the vapor inside the condenser, causing it to condense into a liquid. This process is not dependent on the water being colder at the bottom of the condenser.
The last statement, "Actually, water should go in to the top, not the bottom," is not typically correct for the reasons mentioned above. However, there may be specific types of condensers or experimental setups where this could be the case.
Similar Questions
During the condensation step of the water cycle, water changes state fromChoose 1 answer:Choose 1 answer:(Choice A) water vapor to liquid waterAwater vapor to liquid water(Choice B, Checked) liquid water to iceBliquid water to ice(Choice C) ice to water vaporCice to water vapor
Suggest what would happen to the temperature of the water as it flows through the condenser
Why is it important to run cold water through the condenser?
A cold drink will form condensation on the outside of the can when left out.Identify the correct description of why this happens.There is water vapour in the air surrounding the can. The can is cold, so when the water vapour touches the side of the can the water vapour loses energy. By losing enough energy, the water vapour will form water on the side of the can.There is water vapour in the air surrounding the can. The can is cold, so when the water vapour touches the side of the can the water vapour gains energy. By gaining enough energy, the water vapour will form water on the side of the can.There is water vapour in the air surrounding the can. The can is hot, so when the water vapour touches the side of the can the water vapour loses energy. By losing enough energy, the water vapour will form water on the side of the can.There is water vapour in the air surrounding the can. The can is hot, so when the water vapour touches the side of the can the water vapour gains energy. By gaining enough energy, the water vapour will form water on the side of the can.I DON'T KNOWSUBMIT ANSWER
The apparatus shown below is used for obtaining pure water from a salt solution.Observe the above figure carefully and identify the missing part.A) There should be a stopper each at P and QB) There should be heating of the jacket SC) There should be a stopper at RD) The water should flow through the condenser jacket in the opposite direction.
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.