write objective for the lab report of to determine of the end correction of a meter bridge in points
Question
write objective for the lab report of to determine of the end correction of a meter bridge in points
Solution
-
To understand the concept of a meter bridge and its working principle based on Wheatstone's Bridge.
-
To experimentally determine the end correction of a meter bridge.
-
To analyze the effect of end correction on the accuracy of measurements taken using a meter bridge.
-
To develop skills in setting up the apparatus, making accurate measurements, and handling experimental uncertainties.
-
To interpret the experimental data and draw conclusions about the end correction of a meter bridge.
Similar Questions
In a metre bridge experiment, resistances are connected as shown in the figure. The balancing length 11 is 55 cm. Now, an unknown resistance x is connected in series with P and the new balancing length is found to be 75 cm. The value of x is:
Statement 1In1In a Meter Bridge experiment, null point for an unknown resistance is measured. Now, the unknown resistance is put inside an enclosure maintained at a higher temperature. The null point can be obtained at the same point as before by decreasing the value of the standard resistance.and Statement 2 Resistance of a metal increase with increase in temperature.JEE Advanced 2008 (Paper 1)AStatement 1 is true, Statement 2 is true, Statement 2 is a correct explanation for Statement 1.BStatement 1 is true, Statement 2 is true, Statement 2 is not a correct explanation for Statement 1.CStatement 1 is true, Statement 2 is false.DStatement 1 is false, Statement 2 is true
A train passes two bridges of lengths 500m and 250m in 100 seconds and 60 seconds respectively. The length of the train isa.250mb.125mc.120md.152m
In a single arm strain gauge bridge for force measurement on a brass member, the circuitry is 5m away maintained in a temperature controlled enclosure and connected by copper leads with the gages. The bridge and amplifier together has an overall sensitivity of 10-5 V/N. The resistance of the gauge is 100 and the gauge current which may approximately be measured constant is 25mA. Calculate the limits of error induced by ambient temperature variation in the sensor and the leads in the range 0-50C. the following specification of the strain gauge are given Tempco of gauge factor : +0.75% 100F Tempco of gauge resistance : Matches the member on which the gauge is bonded for zero temperature induced strain Tempco of copper : 43 10-4 / C Tempco of brass : 20 10-4 / C Young’s modulas of brass : 2 1011 N / m2 Resistance of lead : 2m / ohm
Which one of the following is not the correct statement when you are assigned as for bridge site investigations, Bridge site should be__________ except1 pointbe geologically soundbe narrowup at reasonable proximity to the direct alignment of roadshould not possess high banks
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.