When you run the `ps -x` command in Linux, it will display the status of the current processes. The status of each process is shown in the "STAT" column.

If a process is suspended or stopped, it will be indicated by a "T" in the STAT column.

Here are the possible states:

- D: Uninterruptible sleep (usually IO)
- R: Running or runnable (on run queue)
- S: Interruptible sleep (waiting for an event to complete)
- T: Stopped, either by a job control signal or because it is being traced.
- W: Paging (not valid since the 2.6.xx kernel)
- X: Dead (should never be seen)
- Z: Defunct ("zombie") process, terminated but not reaped by its parent.

So, to check if a process is suspended, you would look for a "T" in the STAT column of the output from the `ps -x` command.

Question

When you run the `ps -x` command in Linux, it will display the status of the current processes. The status of each process is shown in the "STAT" column.

If a process is suspended or stopped, it will be indicated by a "T" in the STAT column.

Here are the possible states:

- D: Uninterruptible sleep (usually IO)
- R: Running or runnable (on run queue)
- S: Interruptible sleep (waiting for an event to complete)
- T: Stopped, either by a job control signal or because it is being traced.
- W: Paging (not valid since the 2.6.xx kernel)
- X: Dead (should never be seen)
- Z: Defunct ("zombie") process, terminated but not reaped by its parent.

So, to check if a process is suspended, you would look for a "T" in the STAT column of the output from the `ps -x` command.

Knowee AI · Accepted Answer

When you run the `ps -x` command in Linux, it will display the status of the current processes. The status of each process is shown in the "STAT" column.

If a process is suspended or stopped, it will be indicated by a "T" in the STAT column.

Here are the possible states:

- D: Uninterruptible sleep (usually IO)
- R: Running or runnable (on run queue)
- S: Interruptible sleep (waiting for an event to complete)
- T: Stopped, either by a job control signal or because it is being traced.
- W: Paging (not valid since the 2.6.xx kernel)
- X: Dead (should never be seen)
- Z: Defunct ("zombie") process, terminated but not reaped by its parent.

So, to check if a process is suspended, you would look for a "T" in the STAT column of the output from the `ps -x` command.

When using the ps -x command to check the status of a process in Linux, how would you know if a process is suspended (stopped)?

Question

Solution

Similar Questions

Upgrade your grade with Knowee