How do you determine the difference between the Wet-Bulb and Dry-bulb Temperatures?
Question
How do you determine the difference between the Wet-Bulb and Dry-bulb Temperatures?
Solution
The difference between the wet-bulb and dry-bulb temperatures is known as the wet-bulb depression. Here's how you can determine it:
-
Measure the Dry-Bulb Temperature: This is the ambient air temperature measured by a regular thermometer exposed to the air but shielded from radiation and moisture.
-
Measure the Wet-Bulb Temperature: This is the temperature a parcel of air would have if it were cooled to saturation (100% relative humidity) by the evaporation of water into it, with the latent heat being supplied by the parcel. It is measured by a thermometer that has its bulb wrapped in cloth—kept wet with distilled water—and is then whirled around in the air for a few minutes (or air is blown over the cloth).
-
Subtract the Wet-Bulb Temperature from the Dry-Bulb Temperature: The difference between these two temperatures is the wet-bulb depression. This value can be used to determine relative humidity and dew point temperature.
Remember, the wet-bulb temperature will always be less than or equal to the dry-bulb temperature. The wet-bulb depression is larger in dry air and smaller in moist air.
Similar Questions
The air relative humidity is 20% and its absolute humidity is 0.0045 lb_w / lb_d.a.Using the British units’ map, determine the temperature of the dry bulb (TD.B.) andenthalpy (h)
A student investigates the efficiency of a filament lamp. Fig. 4.1 shows the filament lamp with itsglass bulb immersed in water in a beaker.filament lampto power supplywaterbeakerthermometerFig. 4.1The reading on the thermometer in the water is 19.0 °C.Only the glass of the lamp is in contact with the water and the electrical connections are completelyinsulated.The lamp is switched on.At the end of the experiment, the temperature of the water is 21.5 °C.(a) The mass of the water in the beaker is 600 g and the specific heat capacity of water is4200 J / (kg °C).(i) Show that the increase in the internal energy of the water is 6300 J.[3](ii) In the experiment, the lamp is switched on for 500 s. The power supplied to the filamentlamp is 13 W. The useful energy from the lamp is transferred as light. The energy thatincreases the temperature of the water is wasted energy.Determine the maximum possible efficiency of the filament lamp.maximum possible efficiency = ......................................................... [4]90625/41/M/J/23©UCLES 2023 [Turn over(b) The efficiency of the lamp is less than the value determined in (a)(ii).Suggest one reason for this.................................................................................................................................................................................................................................................................................................................................................................................................................................................... [1]
In the heat stress equation, which of the following terms are given the most consideration in predicting the heat load? dry bulb temperature black globe temperature wet bulb temperature red globe temperature
A flashlight bulb is connected to a dry cell of voltage 4.5 V. It draws 15 mA (1,000 mA = 1 A). Its resistance is 2.5 E2 ohms 3.0 E2 ohms 3.5 E2 ohms 4.0 E2 ohms
Which method can be used to measure the temperature of water?Group of answer choicesMulituse probepH meterColorimetric test paper
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.