There are 2 external inputs you can use to measure the output voltage in your circuit. Which ADCs do these connect to

The external inputs in your circuit can be connected to Analog-to-Digital Converters (ADCs). The specific ADCs these inputs connect to will depend on the design and configuration of your circuit.

Here's a general step-by-step guide:

1. Identify the external inputs: These could be sensors, switches, or other devices that produce a voltage signal.

2. Determine the ADCs in your circuit: Look at your circuit diagram or schematic to find the ADCs. These are usually integrated circuits (ICs) or part of a microcontroller.

3. Connect the inputs to the ADCs: The external inputs should be connected to the input pins of the ADCs. This is usually done using jumper wires or by soldering the connections.

4. Configure the ADCs: Depending on your circuit and the specific ADCs you're using, you may need to configure the ADCs to correctly read the voltage from the external inputs. This could involve setting the reference voltage, choosing the resolution, or programming the ADCs using a microcontroller.

5. Measure the output voltage: Once everything is connected and configured, you can use the ADCs to measure the output voltage from the external inputs. This is usually done by reading the digital output of the ADCs, which represents the analog input voltage.

Remember, the specific steps may vary depending on the specific ADCs and external inputs you're using. Always refer to the datasheets for your components and consult with an electronics expert if you're unsure.